Replacement set of firebricks for the Clearview 750 stove

Replacement Fire Brick Set for Clearview 750 stove.

The Clearview 650 & 750 look very similar so are easily confused.  To avoid ordering the incorrect brick set please measure the height of the rear brick and it should measure approx 328mm high.

Identifying that you have a 750 stove:

The Clearview 650 and 750 look very similar and can easily be mistaken for each other.  To ensue you purchase the correct baffle please check the following guide below:

1) If you can get access to the baffle you will notice there are tabs welded onto the baffle.  IF your baffle has 2 tabs in total (left and right hand side) you have a 650.  If you have 3 tabs (left, right & rear) then you have a 750.

2) The door hinges are slightly different on the two models.  The 650 hinges are almost at the edge of the stove where the 750 hinges are located in around 1" from the edges. See picture below.

Please Note: The Fire bricks within this set is an aftermarket set manufactured from an upgraded higher density British board to exact specificiations.