Clearview Vision Inset Door Rope Seal Kit - P50CP040

In stock
SKU
P50CP040-INSET
£29.99
  • Available for Delivery or Click & Collect (Neyland, Pembrokeshire)
  • Select option at checkout
  • We will Text you when its ready (Click & Collect)

Quality Spares at LOW prices - Stove Spares Ltd

.

Clearview Vision Inset Door Rope Seal Kit

 

Replacement door rope kit suitable for the Clearview Vision Inset stove.

Comes complete with rope and silicone sealant.

Please note: This kit is an aftermarket rope kit so will not arrive in Clearview packaging.  The rope is 100% fully tested by us and many chimney sweeps.  You will receive a slightly longer than required length to avoid the issue of the rope retracting/shrinking in the packet. We will supply fireproof end seal tape so you can seal the end you cut to stop the rope freying and silicone seal also. 

 

Installation Instructions

Installation Instructions:


Installing the Clearview Vision Inset Door Rope Seal Kit is extremely easy and can be completed in around 5-10 minutes.

 

  • Remove old rope seal and clean the cast freeing it of any dirt or old adhesive from the casting.
  • Carefully apply the silicone adhesive into the door rope evenly around the entire door.
  • Carefully apply the rope to the cast edge gently pressing the rope as you go until you have a complete loop around the inner cast.
  • Leave to dry for a minimum of 30 mins before closing the door.

 

Write Your Own Review
You're reviewing:Clearview Vision Inset Door Rope Seal Kit - P50CP040
Your Rating

Fire Brick Warranty Information:

Please note that due to the very nature of firebricks there are no warranties provided by the manufacturers.  Fire bricks are excluded from any warranties in the same way as car brake pads would be due to the many variances that can cause these parts to deteriorate.

When used correctly and carefully fire bricks can last 12 months and sometimes even longer. Please note that using the fire only a few times before the brick cracks does not mean that the brick is faulty as it may have absorbed moisture, a log may have moved during firing and hit the brick or simply been overfired.  Bricks can still be used if cracked.  As long as the crack is not over 6mm wide (Pound coin) then it will still insulate in the same way.

Fore more information please read our full warranty and Tips guide -> CLICK HERE

By placing an order for firebricks you accept these conditions.

Back to Top